Debugger & Programmer

    

The Nuvoton Nu-Link Debug Adapter is a USB debugger and programmer that can debug and program Nuvoton NuMicro® Family Microcontrollers. There are three types of Nu-Link Debug Adapter in accordance with different specifications, including Nu-Link, Nu-Link-Pro, Nu-Link2-Pro.

All Nu-Link Debug Adapters support :
• Memory and flash read/write
• Direct register control in real-time
• Hardware/software breakpoints insert
• Step-run program
• Semihost function under debug mode 

Ordering No. Content Feature Supported Device User Manual
Nu-Link2-Pro
• Nu-Link2-Pro
• 2.54 mm 10-pin Cable
• 2.54 mm 20-pin Cable
• 1.27 mm 20-pin Cable
A high-speed debugger/programmer with ETM trace function :
• ETM trace clock frequency up to 96 MHz
• USB 2.0 HS to SWD bridge
• On-line/off-line ICP up to 24 Mbps
• On-line/off-line ISP firmware update: I2C, SPI, UART, CAN, RS-485
• Supports 3 types of storage devices: Micro SD, USB flash drive, built-in SPI flash
• Programmable output VDD : 1.8 V, 2.5 V, 3.3 V, 5.0 V
• Wide target VDD input level :1.8 V ~ 5.5 V
• Control bus for automatic IC programming system
• Virtual COM port
NuMicro® Family User Manual
Nu-Link-Pro

• Nu-Link-Pro
• 2.54 mm 10-pin Cable

A basic debugger/programmer with programmable output VDD :
• USB 2.0 FS to SWD bridge
• On-line/off-line ICP up to 12 Mbps
• Programmable output VDD : 1.8 V, 2.5 V, 3.3 V, 5.0 V
• Wide target VDD input level : 1.8V ~ 5.5V
NuMicro® Family

User Manual

Nu-Link
• Nu-Link
• 2.54 mm 10-pin Cable
A basic debugger/programmer supports :

• USB 2.0 FS to SWD bridge
• On-line/off-line ICP up to 12 Mbps

NuMicro® Family

User Manual

 

Item Download  Files 
1 Supported IDE • NuEclipse  • KEIL MDK • IAR EWARM
2 Software(Driver) Nu-Link Keil Driver • Nu-Link IAR Driver
3 Programmer Software ICP Programming Tool • Nu-Link Command Tool
4 Debug Tool NuTool-PinView • NuConsole
This website uses cookies to ensure you get the best experience on our website. Learn more