NuMaker-IMU-M487
| 1. | Install the preferred toolchain. Please make sure at least one of the toolchains has been installed. | |
| - | KEIL MDK Nuvoton edition M0 / M23 | |
| 2. | Download and install the latest Nuvoton Nu-Link Driver. Please install the Nu-Link USB Driver as well at the end of the installation. | |
| - | Download and install Nu-Link_Keil_Driver when using Keil MDK. | |
| 3. | Download and unzip the Board Support Package ( BSP ). | |
| 4. | Hardware Setup | |
| (1) Open the virtual COM ( VCOM ) function by changing Nu-Link2-Me VCOM Switch No. 1 and 2 to ON. | ||
|
|
||
| (2) Connect the ICE USB connector to the PC USB port through USB cable. | ||
|
|
||
| (3) Find the “Nuvoton Virtual COM Port” at Device Manger. | ||
|
|
||
| 5. | Download this project file in the resources page. | |
| 6. | Before using the app, please set config.ini file to use Nuvoton Virtual Com Port. | |
 |
||
| 7. | Execute the project APP. Please refer to the user manual in the project file. | |
| 8. | User can see the result in the APP window on PC. | |
|
|
||
|
Resources |
||
|
User Manual | Microcontrollers | Software Development Tool | Driver (BSP) | Programmer | Nuvoton Official Forum | Nuvoton eStore
*Ordering Number : NK-IMUM487 |
||
粤公网安备 44030502010001号