NK-NM18107L
- Install the preferred toolchain. Ensure that at least one of the following toolchains is installed:
- KEIL MDK Nuvoton edition – Full Cortex-M
- IAR EWARM
- Download and install the latest Nuvoton Nu-Link driver:
- For Keil MDK: Download and install Nu-Link_Keil_Driver.
- For IAR EWARM: Download and install Nu-Link_IAR_Driver.
- Download and extract the Board Support Package (BSP) or Motor Drive Example Code.
- Hardware Setup
- Connect the Nu-Link-Me connector (JP10) to the PC's USB port using a USB cable.
- Connect the J63/J52 (U), J64/J53 (V), J65/J57 (W) connectors and the J41 (Hall Sensor) connector to the motor's U/V/W terminals and Hall sensor.
- Connect the J46 or J43 (Vin) and J44 (GND) connectors to the power supply.
- Find the "NM1120_1R_2R_6stp_Hall_FOC.uvprojx" project file in the example code folder.
- [Example Code] NM18107 based Sensor 1R FOC for Fan Appl
- SW
- SampleCode
- UserProj
- KEIL_Reg
- uvprojx
- KEIL_Reg
- UserProj
- SampleCode
- SW
- Open and execute the project in the toolchain. For detailed settings, please refer to "NM18107 應用範例_24V風扇" and "UM_NK-NM18107L V1.0_EN".
- After setting all the required parameters, turn on the VR or VSP to run the motor and verify its performance.
粤公网安备 44030502010001号