NK-NM1240L
- Install the preferred toolchain. Ensure that at least one of the following toolchains is installed:
- Download and install the latest Nuvoton Nu-Link driver:
- For Keil MDK: Download and install Nu-Link_Keil_Driver.
- For IAR EWARM: Download and install Nu-Link_IAR_Driver.
- Download and extract the Board Support Package (BSP) or Motor Drive Example Code.
- Hardware Setup
- Connect the Nu-Link-Me connector (JP3) to the PC's USB port using a USB cable.
- Connect the J6/J7 (U), J3/J4 (V), J1/J2 (W) connectors and the J12 (Hall Sensor) connector to the motor's U/V/W terminals and Hall sensor.
- Connect the J10 or J9 (Vin) and J11 (GND) connectors to the power supply.
- Find the " NM1240_1R_2R_6stp_Hall_FOC.uvprojx" project file in the example code folder.
- [Example Code] NuMotor NM1240_Rev4.1
- SW
- SampleCode
- UserProj
- NM1240_1R_2R_6stp_Hall_FOC.uvprojx
- UserProj
- SampleCode
- SW
- [Example Code] NuMotor NM1240_Rev4.1
- Open and execute the project in the toolchain. For detailed settings, please refer to "UM_NM1244 Sensor based FOC_Rev1.0-EN" and "UM_Motor Demo System-EN_20210512".
- After setting all the required parameters, turn on the VR or VSP to run the motor and verify its performance.
粤公网安备 44030502010001号